Condenser mics need an external 48V phantom power source sent via the XLR cable used to connect the mic to a mixer or audio interface. You can try using any 4 or 6 channel mixer from our wide range of mixers.
Condenser mics are mainly used in the studio settings for recording vocals as they capture clean and high fidelity recordings.
Long press the power button on the back side of the LED light. Once on, you can increase the intensity by short pressing (max. 3 times) on that button.
No, it’s just plug and play. You don’t need any drivers. On mobile phones, you can just do the audio recording on a voice recording app. On a laptop, you can install the DAW software like Audacity.
Use the tripod stand that has a 1/4″ screw where the mobile holder with cold shoe can be fixed. Shotgun mic can easily slide down on to the mobile holder.
SGM–02 comes with 2 cables- one for camera and one for mobile. For camera use the spiral cable and for mobile, use the straight cable. The mobile phone cable is 1ft long, which is sufficient enough for a highly directional mic like shotgun mic as it captures the audio from the front only.
Yes, the shotgun mic is compatible with the cameras that have a 3.5mm jack and a cold shoe mount where the mic can easily slide down to.
The shotgun mic is compatible with mobile phones that have a 3.5mm jack. For phones with Type C or lightning connection, you need an original connector from the phone Company itself.
The shotgun mic is a highly directional mic, thus it can capture the audio till at least 2ft distance only.
If the pairing gets disturbed- long press the frequency pairing button of the transmitter for 2sec till the power light starts flashing. Now long press the frequency pairing button of the receiver for 2sec, the signal light flashes for three times. Once the flashing stops, press the mic pairing button once, the pairing lights will remain stable and will stay turned on.
